Autool BT360 User Manual

AUTOOL Autool BT360 Battery System Tester
14
This is for the convenience of the maintenance personnel to quickly
know the whole state of the starting system according to the data.
After testing finished, do not shut down the engine, press OK key to
enter Charging Test.
3.6 Charging System and Rectifier Diode Test
When enter the charging test, tester will prompt "Charging Test?"
Press OK key again to start the charging test.
NOTE: Do not shut down the engine during the test. All electrical
appliance and device are in OFF state. Turn on/off any electrical
appliance in the vehicle during the test will affect the accuracy of the
test result.
Tester will do the following tests in a sequence:
Operate accordingly to increase the engine rotating speed to
3000turns or above, and keep for 5 seconds.
Tester starts the charging voltage test after increase rotation
detected.
After the test finished, tester displays the effective charging volts,

Autool BT360 Specifications

General

Brand	Autool
Model	BT360
Category	Test Equipment
Language	English