RedBlack
C01 - 1
C01
C02
16
Enter the function item, displayed as shown below:
●
Insert the multi-function detection line into the multi-function
interface (the top of the machine), connect the battery clip line,
clamp the red clip on the positive plate of the car battery, clamp
the black clip on the negative plate of the car battery, and turn
off the car engine;
●
close to zero voltage, connect the probe to one line, press the
up key of the instrument, and observe whether the lamp is on.
If it is not on, replace it with another line. If the lamp is normal,
one line will turn on the lamp when it is powered. If both lines
cannot turn on the lamp when it is powered, the lamp is
damaged.
Car start-up
test
To Next Page
Loading...