Ampere(DC) mA(Green)
<HOLD>Hold
<Fn>Function Mode
<F1>Zero
<F2>20A/mA
0.0mA
Below 200mA Above 200mA
Red Black Red Black
11
In the process of voltage signal measurement, the instrument
automatically changes the range and the maximum measur-
able voltage signal is 1000V;
●
Enter the function item, displayed as shown below:
●
Measure the current below 200mA, insert the red probe into
the green “mAuA” jack, and insert the black probe into the
“COM” jack;
Measure the current above 200mA, insert the red probe into
the yellow “A” jack, and insert the black probe into the “COM”
jack;
●
The current measured value is displayed. If the current fluctu-
ates, press the [HOLD] key to maintain the display status. If
there is no current signal, the displayed value is non-zero, the
red and black probe can be shorted, and press the [F1] key at
the same time to perform the quick zeroing operation. [F2] key
is used to switch the large current measurement, [Fn] key is
used to convert measurements of DC current and AC current.
●
●
Current
measurement
To Next Page
Loading...
Need help?
General