displayed, then press ENTER.
3. Use the pand qarrow keys until 3-Contrast Adj is dis-
played, then press
ENTER.
4. Use the tand uarrow keys to adjust screen contrast. (Fine
adjustment)
5. Use the pand qarrow keys for course adjustment.
6. Press the CONFIG or ENTER key to save settings and
return to the Opening screen.
NOTE: If scanner is left in direct sunlight the Display can turn
completely black. Should this happen put the scanner in a
cool dark place for approx. 10 to 15 minutes the Display
should return to normal.
Set the Display Units (SAE/Metric)
The EZ-Read Code Reader can be set up to display in
SAE or Metric units. The
default setting is SAE. Go to
Section 4 if you do not need to change the display units.
1. To change the unit of measure, press CONFIG from the
initial screen.
2. Use the pand qarrow keys until 2-System Config is
displayed, then press
ENTER.
3. Use the pand qarrow keys to select 1-SAE/Metric, then
press
ENTER.
4. Use the tand uarrow keys to select 1-SAE or 2-METRIC
then press ENTER to select the highlighted choice (or press
the
CONFIG Key to Cancel and return to the initial screen).
Connect the Code Reader to Your Vehicle
The EZ-Read Code Reader communicates with the
computer and sensors in your vehicle through a special
Page 45
SETUP / OPERATING INSTRUCTIONS (CONT.)
To Next Page
Loading...