the battery date may result in damage to the unit.
• As long as good batteries are in the EZ-Read, the vehicle
engine configuration and data will remain in the EZ-Read’s
memory, even after the unit is
powered off.
• Operational data, Trouble Codes, and all remaining scanned
information will remain in memory until the unit is reconfigured.
A
Power Miser Feature automatically powers the unit OFF
after 30 minutes of no activity.
• Refer to “Screen Contrast Problems” on page 25, if needed.
Configure the EZ-Read for Your Vehicle
Before the EZ-Read is used, it must be configured for
your specific vehicle. Don’t worry, it only takes a few steps.
1. Press POWER to turn the unit ON, then press CONFIG.
2. Make sure 1-Config Unit is displayed on the screen, then
press
ENTER.
3. Use the pand qarrow keys until the correct vehicle manufac-
turer name is highlighted, then press
ENTER to select it
(select
OBD-II Generic if your specific OBD-II
manufacturer is not listed).
4. For OBD-I vehicles, use the arrow keys to highlight the
number that matches the 8th character from the VIN
code on the vehicle. Press ENTER to select the proper
character.
NOTE: After the unit is configured, it will Initialize then display
the opening screen. Continue with
Section 3 to set the
display units.
SETUP / OPERATING INSTRUCTIONS (CONT.)
Page 8
To Next Page
Loading...