Adjust the Display Contrast
The contrast on your EZ-Read 1000/2000 can be adjusted
for easier viewing under different lighting conditions.
NOTE: Due to the differences in design not all products
support this feature.
1. To adjust the contrast of the screen press CONFIG key.
2. Use the pand qarrow keys until 2-System Config is
displayed, then press
ENTER.
3. Use the pand qarrow keys until 3-Contrast Adj is dis-
played, then press
ENTER.
4. Use the tand uarrow keys to adjust screen contrast. (Fine
adjustment)
5. Use the pand qarrow keys for course adjustment.
6. Press the CONFIG or ENTER key to save settings and
return to the Opening screen.
NOTE: If scanner is left in direct sunlight the Display can turn
completely black. Should this happen put the scanner in a
cool dark place for approx. 10 to 15 minutes the Display
should return to normal.
Set the Display Units (SAE/Metric)
The EZ-Read EZ-Read can be set up to display in SAE or
Metric units. The
default setting is SAE. Go to Section 4
if you do not need to change the display units.
1. To change the unit of measure, press CONFIG from the
initial screen.
2. Use the pand qarrow keys until 2-System Config is
displayed, then press
ENTER.
3. Use the pand qarrow keys to select 1-SAE/Metric, then
press
ENTER.
SETUP / OPERATING INSTRUCTIONS (CONT.)
Page 9
To Next Page
Loading...