Firmware Upgrade
Firmware Upgrade
The device supports firmware upgrade through either Web UI or
USB-A ports on rear panel.
To upgrade firmware through Web UI, see Firmware Upgrade section.
To upgrade firmware through USB-A port on rear panel, perform the
following:
1. Name the upgrade file package “FSC630-update.zip”.
2. Create a new folder named “upgrade” under the root directory of
a FAT32 or NTFS Udisk. Place the upgrade file in this folder.
3. Connect the Udisk to one of the device’s USB-A ports. It takes
about 1 minute for the device to read the Udisk. If the device
detects the upgrade file is a newer version, it will start upgrading.
When the upgrade process is completed, the device reboots
automatically.
Important:
Do not cut off the power during the upgrade process.
If the device detects the upgrade file is not a newer version, it will
not start upgrading.
To Next Page
Loading...