Avaya 106760804 User Manual

Chapter 11
11-44 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ip routing-mode
Command Mode Interface Configuration.
Description Sets the IP routing mode on an interface. The no form of this command
restores the default setting of RT_MGMT.
Syntax
Sample Output This example enables local packet consumption and disables IP forwarding
on an interface labeled “boston”.
(config-if:boston)# ip routing-mode MGMT_ONLY
Systems P550R, P580, P880, and P882.
To Configure: ip routing-mode {RT_MGMT | RT_ONLY |
MGMT_ONLY}
To Restore
Default:
no ip routing-mode
Table 11-22. Parameters, Keywords, Arguments
Name Definition
{RT_MGMT |
RT_ONLY |
MGMT_ONLY}
• Routing/Mgmt - IP routing is enabled on the
interface, and you can manage the switch
through the interface (from the CLI or Web
Agent).
• Mgmt Only - You can manage the switch
through the interface (from the CLI or Web
Agent), but IP routing is disabled on the
interface.
Note: Do not enable routing protocols on an
interface configured for Mgmt Only since the
interface will act as an end point and will not
pass traffic.
• Routing Only - Routing only interfaces do
not permit management traffic destined for
local interfaces but do allow all other traffic
including management traffic destined for
interfaces on other switches.

Avaya 106760804 Specifications

General

Brand	Avaya
Model	106760804
Category	Switch
Language	English