Figure 19: Headset screen
The following table describes the configuration options on the Headset screen.
Option Function
Active Headset Device Select the active headset device; either USB
or Wired.
Note:
The headset can be selected before it is
attached (wired or USB).
Items below the Active Headset Device field
are dimmed, if either USB headset is not
selected or if the attached headset is not one
of the Human Interface Device (HID)
supported headset types.
Wired Headset Type Select the type of wired headset you
required.
• Headset Type 1 (Generic narrow band)
• Headset Type 2 (Wideband)
• Headset Type 3 (Wideband)
Enable HID Commands Enable HID Commands only if USB headset
is selected.
The checkbox is used to enable the HID
commands of supported headsets to allow the
IP Deskphone to run in generic mode 1
operation, supporting both USB audio and
HID commands. The configuration is ignored
for non-supported USB headsets.
Configuring the Avaya 1120E IP Deskphone
82 Avaya 1120E IP Deskphone with SIP Software User Guide November 2013
Comments? infodev@avaya.com
To Next Page
Loading...
