to all configuration modes and commands that affect operation of the switch (such as
downloading images, rebooting, and so on).
• Global configuration mode:
In the Global Configuration mode (also referred to as config mode), you can set and
display general configurations for the switch such as IP address, SNMP parameters,
Telnet access, and VLANs.
• Interface configuration mode:
In the Interface Configuration mode (also referred to as config-if mode), you can configure
parameters for each port or VLAN, such as speed, duplex mode, and rate-limiting.
It is possible to move between command modes on a limited basis. This is explained in the
Common Procedures section of this document. You can move between command modes on
a limited basis.
For more information about the ACLI command modes, see Avaya Ethernet Routing Switch
3500 Series — Fundamentals. NN47203–102.
General diagnostic tools
26 Troubleshooting March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
