There are three attributes that the RADIUS server sends back to the NAS (switch) for
RADIUSassigned VLANs. These attributes are the same for all RADIUS vendors:
• Tunnel-Medium-Type – 802
• Tunnel-Pvt-Group-ID – <VLAN ID>
• Tunnel-Type – Virtual LANs (VLAN)
Configure switch
The VLAN must be configured correctly on the Ethernet Routing Switch 3500 Series device.
Task flow Configure switch
The following task flow assists you to configure the VLAN on the device.
Figure 29: Configure switch task
EAP RADIUS VLAN is not being applied
Troubleshooting March 2013 73
To Next Page
Loading...
