1. Use the eapol multihost eap-packet-mode unicast command to set the
EAPOL request packet to unicast.
2. Ensure that there are no errors after execution.
Setting EAPOL request packet for a port
Change the EAPOL request packet from multicast to unicast for a specific port.
1. Enter the Interface Configuration mode.
2. Use the eapol multihost eap-packet-mode unicast command to set the
EAPOL request packet to unicast for the interface.
EAP RADIUS VLAN is not being applied
Ensure that the RADIUS VLAN is applied correctly to support EAP.
Work flow EAP RADIUS VLAN is not being applied
The following work flow assists you to determine the cause and solution of the RADIUS VLAN
not being applied.
Troubleshooting authentication
70 Troubleshooting March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
