Figure 31: Configure the switch
Showing EAPOL port
Display the EAPOL port information
1. Use the show eapol port <port> command to display the port information.
2. Ensure that EAP is enabled globally, and that the port EAP status is set to auto.
Setting global EAP enabled and port at eap-auto
Make corrections to ensure that EAP is enabled globally, and that the port EAP status is set
to auto.
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
Configured MAC is not authenticating
Troubleshooting March 2013 77
To Next Page
Loading...
