3. Connect to the switch using the terminal or terminal emulation application.
4. When the switch configuration is set to factory default the following screen appears. Enter
the information requested at each prompt.
Welcome to the 4826GTS-PWR+ setup utility. You will be
requested for information to initially configure for the
switch. When finished the information will be applied and
stored in the switch NVRAM. Once the basic parameters are
configured, additional configuration can proceed using other
management interfaces. Press ^C to abort at any time.
The Quick Start VLAN prompt line appears
Please provide the Quick Start VLAN <1-4094> [1]:
The in-band IP Address prompt line appears
Please provide the in-band IP Address[0.0.0.0]:10.127.232.30
The in-band sub-net mask prompt line appears
Please provide the in-band sub-net mask[0.0.0.0]:255.255.255.0
The Default Gateway prompt line appears
Please provide the Default Gateway[0.0.0.0]:10.127.232.1
The Read-Only Community String prompt line appears
Please provide the Read-Only Community
String[**********]:******
The confirm Read-Only Community String prompt line appears
Please confirm the Read-Only Community
String[**********]:******
The Read-Write Community String prompt line appears
Please provide the Read-Write Community
String[**********]:*******
The confirm Read-Write Community String prompt line appears
Please confirm the Read-Write Community
String[**********]:*******
The in-band IPv6 address prompt line appears
Table continues…
Set IP parameters for the switch
August 2016 Installing Avaya ERS 4800 Series 29
Comments on this document? infodev@avaya.com
To Next Page
Loading...
