Please provide the in-band IPV6 Address/
Prefix_length[1:1:1:1:1:1:1:1/1]:
The in-band IPv6 default gateway appears
Please provide the in-band IPV6 Default Gateway[::]:
The Basic Switch parameters configuration confirmation appears
Basic switch parameters have now been configured and saved.
Note:
The switch uses the default IP address of 192.168.1.1/24 if the switch does not get its IP
address from another source.
Important:
The switch only supports the Avaya CLI, the old 'Bay Stack' menu interface is not supported on
this product. When the switch is set to factory default parameters, the CLI Quickstart appears
which enables you to set default IP information.
Setting IP parameters using the console port and CLI
If the switch is configured beyond factory default settings, perform the following procedure to set IP
parameters using the console port and Command Line Interface (CLI):
1. Connect a terminal to the console port of the switch. You can use a terminal or PC with an
appropriate terminal emulator as the management station. See Setting IP parameters using
the console port and CLI Quickstart on page 28.
2. Set the terminal protocol on the terminal or terminal emulation program to VT100 or VT100/
ANSI.
3. Connect to the switch using the terminal or terminal emulation application.
4. After the Avaya banner appears, press CTRL + Y to display the CLI prompt.
5. To enter the Global Configuration command mode, use the enable command.
6. At the prompt, enter the configure terminal command.
7. At the prompt, enter the ip address command to set the switch or stack IP address.
Following is the ip address command syntax:
ip address [stack | switch} <ip address> [netmak <subnet mask>]
[default-gateway <gateway address>]
The following table describes the ip address command parameters.
Installing the Avaya Ethernet Routing Switch
August 2016 Installing Avaya ERS 4800 Series 30
Comments on this document? infodev@avaya.com
To Next Page
Loading...
