10GBASE-CX specifications
The 10GBASE-CX is a 2-pair twinaxial copper cable that plugs into the SFP+ socket and connects
two 10-gigabit ports. The reach for this cable is up to 15 m with a bit error rate (BER) better than
10
-12
.
The 10GBASE-CX is a lower cost alternative to the optical SFP+ devices.
For more information about the 10GBASE-CX, including test and measurement information and
more specifications, see the IEEE 802.3–2012 standard. The following table identifies the part
numbers for specific cable lengths.
Table 26: 10GBASE-CX cables
Cable length Part number
3 meter AA1403019-E6
5 meter AA1403020-E6
10 meter AA1403018-E6
10GBASE-ZR/ZW SFP+ specifications
The following table lists the transmit and receive specifications for the 10GBASE-ZR/ZW SFP+
transceiver. The part number of this SFP+ transceiver is AA1403016-E6.
Warning:
Risk of BER increase
For proper SFP+ transceiver operation, ensure that at least 11 dB of attenuation is present
between the transmit and receive ports.
The reach for this SFP+ transceiver is up to 70 km* at a wavelength of 1550 nm.
Table 27: 10GBASE-ZR/ZW SFP+ specifications
Parameter Specifications
Line rate (nominal) 10GBASE-ZR 10.3125 Gbps ±100 ppm (10 GbE)
Distance Up to 70 km *
Link optical power budget 24 dB
Dispersion power penalty 3.0 dB at 70 km (G.652 fiber)
Minimum attenuation between transmit and receive
ports
11 dB
Transmitter characteristics
Center wavelength range 1530 to 1565 nm, nominal 1550 nm
Average launch power 0 to 4.0 dBm
Optical modulation amplitude (minimum) –1.7 dBm
Extinction ratio (ER) (minimum) 8.2 dB
Table continues…
SFP+ specifications
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
