Parameter Specifications
Maximum transmitter reflectance –12 dB
Receiver characteristics
Wavelength range 1280 to 1575 nm. Sensitivity specified for 1530 to
1565 nm.
Maximum receiver sensitivity (average power) –24 dBm
Maximum receiver (average) power, BER 10
-12
–7.0 dBm
Receiver damage threshold (average power) +5.0 dBm
Receiver reflectance (maximum) –27 dB
* Achievable link distance is primarily dependent on cable plant insertion loss. 70 km is not possible
in some situations.
10GBASE-ER CWDM DDI SFP+ specifications
The following table lists the part numbers of the 10GBASE-ER CWDM DDI SFP+ with
corresponding wavelengths.
Table 28: Part number and center wavelength assignment
Part number Center
wavelength
assignment
Reach Insertion loss
Tx to Rx
AA1403153-E6 1471 nm up to 40 km 5 dB
AA1403154-E6 1491 nm up to 40 km 5 dB
AA1403155-E6 1511 nm up to 40 km 5 dB
AA1403156-E6 1531 nm up to 40 km 5 dB
AA1403157-E6 1551 nm up to 40 km 5 dB
AA1403158-E6 1571 nm up to 40 km 5 dB
AA1403159-E6 1591 nm up to 40 km 5 dB
AA1403160-E6 1611 nm up to 40 km 5 dB
The following table lists the transmitter and receiver specifications for the 10GBASE-ER CWDM DDI
SFP+.
Table 29: 10GBASE-ER CWDM DDI SFP+ specifications
Parameter Specifications
Transmitter characteristics:
Optical Data Rate (nominal) 9.95 Gbps to 10.313 Gbps
Center wavelength Nominal –6.5 nm to nominal +6.5 nm
Spectral width (RMS at –20 dB) 1 nm
Table continues…
SFP+
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 52
Comments on this document? infodev@avaya.com
To Next Page
Loading...
