Avaya C360 - Installing the Java Plug-in

Maintenance
208 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Hardware NVRAM Initialization
If you wish to perform a hardware NVRAM initialization, then perform the following steps:
!
CAUTION:
CAUTION: C360 switches and stacking modules contain components sensitive to
electrostatic discharge. Touching the circuit boards unless instructed to do so
may damage them.
!
PRECAUCIÓN:
PRECAUCION: El switch C360 y sus módulos de ampliación contienen componentes sensibles a
descargas electrostáticas. Tocar las tarjetas sin autorización del personal técnico
puede dañarlas.
!
CAUTION:
CAUTION: Do not leave the stacking slots open. Cover empty slots using the blanking plates
supplied.
!
PRECAUCIÓN:
PRECAUCION: No deje las aberturas de ampliación abiertas. Cubrir las aberturas vacias con las
placas bloqueadoras proporcionadas con el equipo.
1. Remove the bridge from the jumper labelled "SPARE JUMPER" on the PCB.
2. Bridge the NVRAM INIT jumper before inserting the X360STK module.
- See Figure 37
for the location of the jumpers.