Mixed Stacks
214 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Hardware Compatibility
This section describes hardware compatibility issues.
Stacking
Tip:
Tip: It is recommended to put the C360 switches at the bottom or top of a mixed stack
for easier connection of cables.
You may use the same Octaplane cables for stacking all the switches. However, the stacking
modules are not interchangeable. Please refer to Table 36
for information on which stacking
module to use.
1. You should use Stacking Modules version C/S:1.x or higher.
Table 37: Stacking Module Compatibility
Switch Stacking Module
C360 X360STK (refer to Installing the
X360STK Stacking Module on
page 41 for further information)
G700 X330STK
1
P333T-PWR X330STK
1
P332G-ML X330STK-ML
P332GT-ML X330STK-ML
To Next Page
Loading...
