Establishing Switch Access
62 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Entering the CLI
To enter the CLI, enter your username and password. Your access level is indicated in the
prompt as shown in Table 14
.
Establishing a Console Connection
This section describes the procedure for establishing switch access between a terminal and the
C360 switch over the serial port provided on the front panel of the C360 (RJ-45 connector
labeled "Console"). For information on the console port pin assignments, refer to Console Pin
Assignments on page 230.
Figure 20: C360 Console Port
Table 14: CLI Prompts (Layer 2)
Level Prompt
User (read-only) C360-N>
Privileged (read-write) C360-N#
Supervisor C360-N(super)#
Configure C360-N(configure)#
Figure notes:
1. Console Port
1
To Next Page
Loading...
