Avaya C360 - Page 72

To Next Page

To Previous Page

Establishing Switch Access

72 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5

9. You can now dial into the switch from a remote station, and open a Telnet session to the

PPP interface IP address.

Main Page

Default Chapter3
- Table of Contents3
Before You Install the Avaya C36013
- Safety Information13
- Conventions Used in the Documentation14
  - CLI Conventions14
  - Notes, Cautions, and Warnings15
Section 1: Avaya C360 Overview17
Chapter 1: Avaya C360 Overview19
- C360 Features and Benefits19
- C360 Switch Configurations26
Section 2: Installing the C36027
Chapter 2: Avaya C360 Front and Rear Panels29
- C360 Front Panels29
- C360 Rear Panel33
Chapter 3: Installation35
- Preparing Needed Tools35
- Site Preparation36
- Rack Mounting (Optional)37
  - Before You Install the C360 in a Rack38
- Wall Mounting (Optional)40
- Stacking (Optional)41
  - Installing the X360STK Stacking Module41
  - Inter-Connecting Switches42
    - To Connect Stacked Switches42
- Making Connections to Network Equipment44
  - Prerequisites44
  - Connecting Cables to Network Equipment44
- Installing SFP GBIC Transceivers45
  - Safety Information45
    - Usage Restriction45
  - Installing and Removing a SFP GBIC Transceiver46
    - Copper GBIC Transceiver Installation Notes47
Chapter 4: Powering up the Avaya C36049
- Connecting to an AC Power Supply50
  - AC Power Cable50
- Connecting to a DC Power Source (C364T NEBS Only)51
- Connecting a BUPS53
- Post-Installation58
Chapter 5: Establishing Switch Access59
- CLI Architecture60
- Security Levels60
  - Entering the Supervisor Level61
    - Defining New Local Users61
    - Exiting the Supervisor Level61
- Entering the CLI62
- Establishing a Console Connection62
- Assigning C360 IP Stack Address64
- Establishing a Telnet Connection65
- Establishing an SSH Connection66
- Establishing Access to Other Entities in the Stack (C360 Sessions)70
- Establishing a Modem (PPP) Connection71
  - Connecting a Modem to the Console Port71
- SNMP Support73
- Radius80
  - Introduction to RADIUS80
  - RADIUS Commands82
- Recovery Password83
  - Introduction to Recovery Password83
  - Recovery Password CLI Commands83
- Allowed Managers84
  - Allowed Managers Introduction84
  - Allowed Managers CLI Commands84
- Allowed Protocols86
  - Allowed Protocols Introduction86
  - Allowed Protocols CLI Commands86
Section 3: Avaya C360 Configuration89
Chapter 6: Avaya C360 Default Settings91
- Configuring the Switch91
  - C360 Default Settings91
Chapter 7: Switch Configuration95
- Introduction95
- Basic Switch Configuration95
  - System Parameter Configuration96
    - Identifying the System96
    - Operating Parameters97
  - Network Time Acquiring Protocols Parameter Configuration97
- Uploading and Downloading Device Configurations and Images99
  - Layer 2 Configuration File100
  - Layer 3 Configuration File101
- SCP Protocol Support103
- System Logging104
  - System Logging Introduction104
  - Syslog Servers106
- Telnet Client Support109
  - Introduction to Telnet109
  - Telnet Commands109
- Monitoring CPU Utilization110
Chapter 8: Avaya C360 Layer 2 Features111
- Ethernet111
- Vlans117
- IEEE 802.1X (Port Based Network Access Control)123
- Spanning Tree Protocol127
- MAC Security132
  - MAC Security Implementation in the C360132
  - MAC Security CLI Commands133
- LAG (Link Aggregate Group)134
- Port Redundancy135
- IP Multicast Filtering139
  - IP Multicast CLI Commands141
- Rmon141
  - RMON Overview141
  - RMON CLI Commands142
- Smon143
  - SMON Overview143
    - SMON CLI Commands144
- Port Mirroring144
- Weighted Queuing145
  - Implementation of Weighted Queuing in the C360145
  - Weighted Queuing CLI Commands146
- LLDP Agent146
Chapter 9: Avaya C360 Layer 3 Features151
- Obtaining and Activating a License Key151
  - Obtaining a Routing License Key152
  - Activating a Routing License Key158
    - License Key CLI Commands158
- What Is Routing158
- Routing Configuration161
  - Forwarding161
  - Multinetting (Multiple Subnets Per VLAN)161
- IP Configuration162
  - IP Configuration CLI Commands162
  - Assigning Initial Router Parameters163
- RIP (Routing Interchange Protocol) Configuration164
- OSPF (Open Shortest Path First) Configuration167
  - OSPF Overview167
  - OSPF CLI Commands168
- Static Routing Configuration169
- Route Redistribution171
  - Route Redistribution Commands172
- ARP (Address Resolution Protocol) Table Configuration172
  - ARP Overview172
    - The ARP Table173
  - ARP CLI Commands174
- BOOTP/DHCP (Dynamic Host Configuration Protocol) Relay Configuration175
  - BOOTP/DHCP Overview175
  - BOOTP/DHCP CLI Commands176
- Netbios Re-Broadcast Configuration176
  - Netbios Overview176
  - Netbios Re-Broadcast Configuration CLI Commands177
- VRRP (Virtual Router Redundancy Protocol) Configuration177
- Policy Configuration180
- IP Fragmentation and Reassembly184
  - IP Fragmentation and Reassembly Overview184
  - IP Fragmentation/Reassembly CLI Commands185
Chapter 10: Avaya C360 Power over Ethernet Features187
- Power over Ethernet187
Chapter 11: C360 Device Manager193
- Overview193
- System Requirements194
- Configuring the Device Manager194
  - Device Manager Commands194
- Running the Device Manager195
- Installing the Java Plug-In197
- Installing the On-Line Help and Java Plug-In on Your Web Site198
- Documentation198
Section 4: Troubleshooting and Maintaining the Avaya C360199
Chapter 12: Troubleshooting the Installation201
- Troubleshooting the Installation201
- Stack Health204
Chapter 13: Maintenance207
- Introduction207
- Replacing the Stacking Module207
- Hardware NVRAM Initialization208
Chapter 14: Updating the Firmware211
- Firmware Download211
  - Obtain Software Online211
  - Downloading Firmware211
- Download New Version Without Overwriting Existing Version212
  - Firmware Banks212
Appendix A: Mixed Stacks213
- Hardware Compatibility214
  - Stacking214
  - Bups215
- Feature Compatibility216
  - Qos Mapping217
Appendix B: Configuring C360 Qos for Avaya IP Telephones219
- Introduction219
Appendix C: Standards and Compatibility221
- Avaya C360 Standards Supported221
- IETF - Network Monitoring223
Appendix D: Specifications225
- Physical225
- Power Requirements226
- Environmental227
- Safety227
- Mtbf228
- Interfaces228
- GBIC Transceivers228
- Console Pin Assignments230
- Ethernet231
Index233

Avaya C360 - Page 72

Table of Contents

Other manuals for Avaya C360

Related product manuals