Configuring the Switch
Issue 1 July 2006 93
Tip:
Tip: Functions operate in their default settings unless configured otherwise.
Table 22: Default Port Settings
Function Default Setting
Ports 1 to 24
or 1 to 48
Ports 51 and 52
Duplex mode Half/Full
duplex
depending on
auto-negotiati
on results
Full duplex only
Port speed 10/100 Mbps
Depending on
auto-
negotiation
results
1000 Mbps
Auto-negotiation
1
1. Ensure that the other side is also set to Autonegotiation
Enabled.
Enable Enable
Flow control Disabled (no
pause)
Disabled (no
pause)
Flow control
auto-negotiation
advertisement
Not applicable Disabled (no
pause)
Administrative state Enable Enable
Port VLAN ID 1 1
Eavesdropping
Prevention
Intrusion Prevention
Tagging mode Clear Clear
Port priority 0 0
Spanning Tree cost 19 4
Spanning Tree port
priority
128 128
To Next Page
Loading...
