Procedure: Software Installation
Issue 6 September 2001
2-3
Figure 2-2. Optional Features Form (Page 4)
3. Change the Wireless field value from n to y.
4. Submit the form.
5. Log off and then log on again to the DEFINITY ECS local or remote MT as
init.
6. Execute the change system-parameters wireless command to generate
the Wireless System-Parameters form. Two versions of the form are shown
in the following figures:
OPTIONAL FEATURES
Page 4 of 10display system parameters customer-options
Tenant Partitioning? n
Time of Day Routing? n
Uniform Dialing Plan? y
Usage Allocation Enhancements? y
VAL Full 1-Hour Capacity? n
Processor and System MSP? n
Private Networking? y
(NOTE: You must logoff & login to effect the permission changes.)
Remote Office? n
Restrict Call Forward Off Net? y
Secondary Data Module? y
Wideband Switching? n
Wireless? y
Station and Trunk MSP? n
Station as Virtual Extension? n
Survivable Remote Processor? n
Terminal Trans. Init. (TTI)? y
To Next Page
Loading...
