Procedure: Software Installation
Issue 6 September 2001
2-5
Figure 2-4. Wireless-Related System Parameters Form (G3si/vs/Prologix
™
)
7. Allow the administrable part of the System Identification field to remain at the default
value of 2176.
NOTE:
This field provides the system with an identifier that is broadcast
regularly in its beacon or traffic-bearing channels. The system ID
includes two parts: system-generated digits and administrable digits.
The system-generated part is displayed as a read-only prefix to the
administrable part.
If this field is changed, you must busy out, reset, and release all
administered RCs before the change will be read into the RCs. The
new system ID must be programmed into all new and existing handsets. It is
not recommended that this field be changed.
This field will change if the wireless customer option is changed to n then y
after the initial provisioning.
WIRELESS-RELATED SYSTEM PARAMETERS
System Identification: 0100015-2176
change system-parameters wireless
Allowable Carrier Frequencies (MHz)
0: 1929.375
y
Master Port Network: 1
1: 1928.125
y
2: 1926.875 y
3: 1925.625
y
4: 1924.375 y
5: 1923.125
y
6: 1921.875 y
7: 1920.625 y
Radio Transmission: y
Maximum Radio Controllers: 10
Maximum Wireless Terminals: 200
Port Networks With Radio Controllers
1:
y
2: n
3: n
Page 1 of 1
UTAM Disablement? y
To Next Page
Loading...
Need help?
General
