Prepare for Configuration
26 Quick Start for Hardware Installation: Avaya G430 Media Gateway
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
DRAFT - January 25, 2009 - 1:38 PM
a. From the navigation menu of the Maintenance Web Pages, select Security > Modem. The
Modem screen appears.
b. Select Enable modem for unlimited incoming calls.
c. Click Submit.
4. To ensure that the modem is enabled correctly:
a. Setup a dialup connection on a remote PC with the following settings:
- Automatically detect settings.
- No Username, Password, or Domain.
- Security > Show Terminal Window.
b. Dial in to the modem from the remote PC.
c. When prompted, provide the rasaccess login and password in the Terminal Window.
d. Close the Terminal Window to complete the connection.
5. A remote technician can now access the S8300 remotely and run Avaya IW.
Configuring a G430 without an S8300 Server
You use the Gateway Installation Wizard (GIW) to configure the Avaya G430 Media Gateway without an
S8300. You can perform the configuration on site, or prepare the G430 for a remote configuration.
1. Prepare a laptop with a CD-ROM drive, SSH client software, and a TFTP server on the network.
This may be needed for installing software and firmware upgrades
2. Install the GIW software on your laptop. You can download the GIW software from the Avaya support
Web site, at http://support.avaya.com/avayaiw
and go to File Downloads.
3. Set the laptop's TCP/IP properties as follows:
- IP address: 192.11.13.5
- Subnet mask: 255.255.255.252
- Disable DNS service
- Disable WINS Resolution
4. Connect an Ethernet cable from the laptop computer to the G430 Services port.
5. Double-click the GIW icon on the laptop to open the Gateway Installation Wizard. The Overview
screen appears.
6. Click Continue. The
Gateway Connection Details screen appears.
7. Select Select if this is a G430 Gateway.
8. Enter the Username and Password {?which?}.
9. Click Continue. The Initializing the Components screen appears.
10. Select Initialize the Gateway Installation Session.
11. Click Continue. The Wizard Usage Options screen appears.
To Next Page
