Avaya IP Office 8.1 - 22. Technical Specifications

Product Description
IP Office 8.1
© 2012 AVAYA All rights reserved.
Page 436
Issue 26.k.- (16 August 2012)
22. Technical Specifications
PC requirements and specifications of the various IP Office applications can be found in a separate document in
the IP Office section of support.avaya.com.
Dimensions
Unit Dimensions (mm/inches)
Width
Height
Depth
IP500 and IP500 V2
445mmm/17.5"
73mm/2.9"
365mm/14.4"
· The recommended minimum clearance, front and rear, for the connection of cables and other devices is
75mm/3".
Weight
Unit
Weight
IP500 Control Unit
3.2Kg/7.0lbs
IP500 V2 Control Unit
3.2Kg/7.0lbs
IP412 Control Unit
3.0Kg/6.7lbs
Analog 16 Module
2.9Kg/6.5lbs
DS16 Module
3.0Kg/6.7lbs
DS30 Module
3.5Kg/7.8lbs
DS16A Module
3.0Kg/6.7lbs
DS30A Module
3.5Kg/7.8lbs
TCM8
0.4Kg/0.9lbs
WAN3 Module
2.8Kg/6.3lbs
So8 Module
2.8Kg/6.3lbs
Phone 8 Module
2.8Kg/6.3lbs
Phone 16 Module
2.9Kg/6.5lbs
Phone 30 Module
3.1Kg/6.94lbs
Environmental
· 0°C to +40°C (32°F to 104°F). 95% relative humidity, non-condensing.
Call Capacity
Busy Hour Call Complete (BHCC) is a measure used to test IP Office systems under a high call load. For BHCC
tests, each incoming call rings for 5 seconds, is answered and stays connected for 6 seconds. The BHCC figures
for the different IP Office control units are listed below. Note that in some cases the BHCC figure achievable will
be limited by the number of incoming trunks supported.
· IP500 = 36000.
· IP500 V2 = 36000.