Avaya J100 - Page 105

Name Description
WLAN Active SSID Displays active SSID when Wi-Fi is active. This is an internal
parameter.
Value format: a sting from 0 to 32 characters. The default value
is empty.
SSID Specifies the SSID string of the Wi-Fi network.
Value format: alphanumeric characters and special symbols.
Note:
The space character (ASCII 0x20) is not supported.
The default value is empty.
Security Specifies the WLAN security standard for your Wi-Fi network.
The options are:
• None (default)
• WEP Security
• WPA/WPA2 security (pre-shared key) security
• WPA2 Enterprise security (802.1x auth.)
WLAN Max Authentication Retires Specifies the number of retries that will be attempted to
establish a secure connection upon receiving authentication
failures.
The options are:
• 0
• 1
• 2
• 3 (default)
• 4
IP Configuration
Use DHCP Specifies whether DHCP is used in the Wi-Fi network.
The options are:
• Yes (default)
• No
IP Address Specifies the IP address of the phone.
The valid value is the IP address in the dotted decimal name
format. The maximum number of characters is 15.
The default value is “0.0.0.0”.
Table continues…
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 105
Comments on this document? infodev@avaya.com