Avaya J100 - Page 110

Name Description
SIP User ID Specifies the SIP user ID used to log in to the phone.
You can also type the SIP user ID, which is a combination of the following
values:
• Upper and lower case characters.
• Numbers from 0 to 9.
• Spaces.
• Special characters. The allowed characters are the following: . , : ; “” ‘’ / ()
{} [] ` ~ * _ ! ? + - ^ # = <> | & $ —
The default value is empty.
Authentication User ID Specifies the authentication ID.
You can also type the authentication user ID in this field if authentication is
enabled on the SIP server.
The authentication user ID is a combination of the following values:
• Upper and lower case characters.
• Numbers from 0 to 9.
• Spaces.
• Special characters. The allowed characters are the following: . , : ; “” ‘’ / ()
{} [] ` ~ * _ ! ? + - ^ # = <> | & $ —
Authentication Password Specifies the authentication password.
You can also type the password in this field if authentication is enabled on
the SIP server.
Note:
The password can contain maximum 31 ASCII characters.
The default value is empty.
SIP Global Settings
SIP Domain Specifies the SIP domain used for SIP registration.
The valid value is a string of 0 to 255 ASCII characters.
Enable PPM as source of
Proxy Server
Specifies whether PPM is used as a source of SIP proxy server
information.
Note:
This is an Avaya Aura
®
setting which is ignored in an Open SIP
environment.
The options are:
• Yes (default)
• No
Table continues…
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 110
Comments on this document? infodev@avaya.com