Avaya J100 - Page 253

Parameter name Default
value
Description
ENABLE_SIP_USER_ID 0 Specifies that the SIP User ID field
is required under ADMIN > SIP >
SIP Global Settings.
Value operation:
• 0: Disabled
• 1: Enabled
ENABLE_STRICT_USER_VALIDATION 0 Specifies that the validation is done
for the To header and Request-
URI against AOR and Contact
header during phone registration.
Value operation:
• 0: No validation.
• 1: Validates the phone
registration.
ENCRYPT_SRTCP 0 Specifies whether RTCP packets
are encrypted or not. SRTCP is
only used if SRTP is enabled using
MEDIAENCRYTIONRTCP.
ENCRYPT_SRTCP parameter
controls RTCP encryption for RTCP
packets exchanged between peers.
RTCP packets sent to Voice
Monitoring Tools are always sent
unencrypted.
Value operation:
• 0: SRTCP is disabled.
• 1: SRTCP is enabled.
ENFORCE_SIPS_URI 1 Specifies if a SIPS URI must be
used for SRTP.
Value operation:
• 0: Not enforced
• 1: Enforced
Table continues…
List of configuration parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 253
Comments on this document? infodev@avaya.com