Avaya J100 - Page 252

Parameter name Default
value
Description
ENABLE_SHOW_EMERG_SK 2 Specifies whether an Emergency
softkey, with or without a
confirmation screen, is displayed
when the phone is registered. All
emergency numbers are always
supported.
Value operation:
• 0: Emergency softkey is not
displayed.
• 1: Emergency softkey is
displayed without a confirmation
screen.
• 2: Emergency softkey is
displayed with a confirmation
screen.
Note:
The parameter is set to 0 for
IP Office environment.
ENABLE_SHOW_EMERG_SK_UNREG 2 Specifies whether an Emergency
softkey, with or without a
confirmation screen, is displayed
when the phone is not registered.
All emergency numbers will always
be supported.
Value operation:
• 0: Emergency softkey is not
displayed.
• 1: Emergency softkey is
displayed without a confirmation
screen.
• 2: Emergency softkey is
displayed with a confirmation
screen.
Note:
The parameter is set to 0 for
IP Office environment.
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 252
Comments on this document? infodev@avaya.com