Avaya J129 - Page 224

Parameter name Default
value
Description
available on the called or remote
party.
Valid values are from 5 to 20
seconds.
FORCE_SIP_EXTENSION Null Replaces User ID entered by the
user during login.
FORCE_SIP_PASSWORD Null Replaces password entered by the
user during login.
FORCE_SIP_USERNAME Null Replaces the user field entered by
the user during login.
FORCE_WEB_ADMIN_PASSWORD Null Specifies the password to access
the phone through Web as
Administrator.
Valid values are 8 to 31
alphanumeric characters.
FQDN_IP_MAP Null Specifies a comma separated list of
name or value pairs where the
name is an FQDN and the value is
an IP address. The IP address may
be IPv6 or IPv4 but the value can
only contain one IP address. String
length is up to 255 characters
without any intervening spaces
inside the string. The purpose of
this parameter is to support cases
where the server certificate Subject
Common Name of Subject
Alternative Names includes FQDN,
instead of IP address, and the
SIP_CONTROLLER_LIST is
defined using IP address. This
parameter is supported with phone
service running over TLS, however,
the main use case is for Avaya
Aura SM/PPM services. This
parameter must not to be used as
an alternative to a DNS lookup or
reverse DNS lookup.
G
G726_PAYLOAD_TYPE 110 Specifies the RTP payload type to
be used for the G.726 codec.
Valid values are 96 through 127.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 224
Comments on this document? infodev@avaya.com