Avaya J129 - Page 229

Parameter name Default
value
Description
Valid values are 1 through 10.
IPV6DADXMITS 1 Specifies whether Duplicate
Address Detection is performed on
tentative addresses, as specified in
RFC 4862.
Value operation:
• 0: DAD is disabled
• 1 to 5: Maximum number of
transmitted Neighbor Solicitation
messages.
IPV6STAT 0 Specifies whether IPv6 will be
supported or not.
Value operation:
• 0: IPv6 will not be supported.
• 1: IPv6 will be supported.
K
L
L2Q 0 Specifies whether the VLAN
tagging is enabled or disabled.
Value Operation:
• 0: Auto. VLAN tagging is turned
on when the network can support
VLAN tagging and L2QVLAN is
non zero.
• 1: On. VLAN tagging is turned on
when the network can support
VLAN tagging. The IP phone
sends tagged frames with VLAN
= L2QVLAN, even if L2QVLAN is
set to 0.
• 2: Off. VLAN functionality is
disabled.
Note:
This parameter can also be
set through:
• Local admin procedure
• A name equal to value pair
in DHCPACK message
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 229
Comments on this document? infodev@avaya.com