Avaya J129 - Page 228

Parameter name Default
value
Description
spaces. The format of specifying IP
addresses are:
• Dotted decimal
• Colon-hex
• DNS name
The parameter can be set by using
LLDP.
Valid values contains 0 to 255
ASCII characters.
I
ICMPDU Specifies if ICMP Destination
Unreachable messages are
generated.
Value Operation:
• 0: No messages are generated.
• 1: Limited port unreachable
messages are generated.
• 2: Protocol and port unreachable
messages are generated.
ICMPRED Specifies if received ICMP Redirect
messages are processed.
Value Operation:
• 0: No
• 1: Yes
INGRESS_DTMF_VOL_LEVEL -12dBm Specifies the power level of tone,
expressed in dBm0.
Values can range from -20dBm to
-7dBm.
INSTANT_MSG_ENABLED 1 Specifies whether Instant
Messaging is enabled or disabled.
Value Operation:
• 0: Disabled
• 1: Enabled
INTER_DIGIT_TIMEOUT 5 Specifies the number of seconds
that the phone waits after a digit is
dialed before sending a SIP
INVITE.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 228
Comments on this document? infodev@avaya.com