Avaya J129 - Page 50

Name Description
VLAN
VLAN Specifies whether the VLAN tagging is enabled or disabled.
The options are:
• Auto (default): To support VLAN functionality by using the phone
network.
• On: To support the VLAN functionality by using the internal switch of
the phone.
• Off: To disable the VLAN functionality of the phone.
VLAN ID Specifies the VLAN ID. To assign a VLAN ID, type the VLAN ID.
Configure this parameter if the phone uses a different VLAN than the
default data VLAN.
The valid value is an integer from 0 to 4094. The default value is 0.
VLAN Separation Mode Specifies the VLAN separation mode.
The options are:
• Enabled (default)
• Disabled
VLAN Test - Wait Time for
DHCP Offer
Specifies the wait time interval in seconds to receive a DHCPOFFER
on a non-zero VLAN.
The valid value is an integer from 0 to 999. The default value is 60
seconds.
PC Port VLAN ID Specifies the VLAN ID of the computer port.
The valid value is an integer from 0 to 4094. The default value is 0.
Tags to PC Ethernet Interface Specifies whether the VLAN tags are stripped from Ethernet frames
that leave the computer port.
The options are:
• Do not remove
• Remove (default)
QoS
Audio Priority (Layer 2) Specifies the Layer 2 priority value for audio (RTP and RTCP) streams.
The valid value is an integer from 0 to 7. The default value is 6.
Signaling Priority (Layer 2) Specifies the Layer 2 priority value for signaling protocol messages.
The valid value is an integer from 0 to 7. The default value is 6.
Audio DiffServ (Layer 3) Specifies the layer 3 Differentiated Services (DiffServ) code point for
audio frames generated by the phone.
The valid value is an integer from 0 to 63. The default value is 46.
Table continues…
Configuring the phone using web interface
December 2018 Installing and Administering Avaya J100 Series IP Phones 50
Comments on this document? infodev@avaya.com