Job Aid Replacing the Avaya S8700 Media Server—Release 2.0 and Later
Replacing the S8700 Media Server
12 Replacing the Media Server with Release 2.0—S8700
555-245-767, Issue 1.1 December 2003
Figure 1: Removing and replacing the cover on the media server
Removing the hard drive from the media
server
For these steps, see Figure 2, Hard drive bracket and hard drive, on page 13
1 Open the bezel on the front of the media server, and use a #2 cross-point (Phillips) screwdriver to
unscrew the two screws on the faceplate of the hard drive bracket.
NOTE:
The hard drive bracket is on the front right-hand side of the S8700 Media Server.
2 Partially pull out the hard drive bracket so that you can disconnect the cables. Note the position of
the ribbon cable within the chassis so you can return it to exactly the same position later.
3 Unplug the 4-wire power cable from the back of the hard drive.
4 Unplug the ribbon cable from the back of the hard drive. Note that the red stripe on the ribbon
cable is on the side closest to the power cable.
5 Pull the hard drive bracket from the media server, and place the hard drive and bracket assembly
on your antistatic mat.
1 Hex-head bracket screws
2 Cross-point (Phillips) cover screws
3 S8700 media server cover tabs
4 Inner rail guide
5 Bottom rail of media server
bkdsopen LAO051303
U1
U2
1
2
3
4
5
1
2
3
To Next Page
Loading...
