Avaya S8700 - Final tasks

Job Aid Replacing the Avaya S8700 Media Server—Release 2.0 and Later
Final tasks
6 Replacing the Media Server with Release 2.0—S8700
555-245-767, Issue 1.1 December 2003
Final tasks
If you are reusing the old hard drive, follow the procedure in Final tasks for replacing an S8700 Media
Server reusing the original hard drive on page 9
If not reusing the old hard drive, you must install the Linux operating system and Avaya Communication
Manager on the blank hard drive, then restore the backed up system files to the media server. Follow the
procedure in Final tasks for replacing an S8700 Media Server using the blank hard drive
on page 6.
Except where noted in the following checklist, see Upgrading Software and Firmware— Avaya S8700
Media Server (555-245-115) on the Avaya S8300, S8500, and S8700 Media Server Library CD-ROM,
555-233-825, Issue 3, for details on the tasks.
Checklist 5. Final tasks for replacing an S8700 Media Server using the blank hard drive
9 Task Description
1 Connect laptop to the
replacement media server
Connect the laptop to the services port on the back of the media
server.
2 Set Telnet parameters (if
necessary)
Open a Telnet session and type telnet and press Enter.
Type
unset crlf and press Enter.
Type
display and press Enter to verify that message says
Sending only CR
Type exit and press Enter to close Telnet session.
3 Install Communication Manager You must install the software from the CD. For procedure details,
see Installing the softwar
e on page 15.
4 Log onto the Maintenance Web
Interface
Open a browser on your laptop. Use 192.11.13.6 to log onto the
Maintenance Web Interface.
Note: Use the initial installation craft login and initial password.
5 Check software version Under Server, click Software Version to verify that the hard drive
has the correct release of Communication Manager.
6 Copy software update (patch)
files to media server (if any)
Under Miscellaneous, click Download Files.
Browse to select the file for downloading and click Download.