Avaya S8700 - Page 9

Job Aid Replacing the Avaya S8700 Media Server—Release 2.0 and Later
Final tasks
Replacing the Media Server with Release 2.0—S8700 9
December 2003 555-245-767, Issue 1.1
23 Set the Product ID on the
replacement media server
Type productid -p product_id, where product_id is the product
ID you received from the customer or the ART tool. It should be
the same product ID as the old media server.
24 Release alarm suppression on the
replacement media server
Using telnet on the Linux command prompt screen, type
almsuppress -n and press Enter to release alarm suppression.
Note: Only do this if you want to release it before the time you set
earlier runs out (maximum of 2 hours)
25 Log off all administration
applications
When you have completed all the administration, log off the media
server.
Checklist 5. Final tasks for replacing an S8700 Media Server using the blank hard drive
9 Task Description
Checklist 6. Final tasks for replacing an S8700 Media Server reusing the original hard drive
9 Task Description
1 Connect laptop to the
replacement media server
Connect to the services port on the back of the media server.
2 Log onto the Maintenance Web
Interface
Open a browser on your laptop. Use 192.11.13.6 to log onto the
Maintenance Web Interface.
3 Verify busied out status Under Server, click Status Summary. Make sure the standby
media server is busied out.
4 Reattach all cables Connect the fiber duplication cable and the Ethernet duplication
cable to the replacement media server. Connect all the other
cables.
5 Ping the connections on the
replacement media server
Under Diagnostics, click Ping. Ensure that all administered
connections respond.
6 Release media server with
replacement hard drive and
monitor the refresh
Under Server, click Release Server to release the media server.
Click Status Summary to verify that the media server is no longer
busied out. Monitor the refresh of the media server until it is
complete.
Verify the following:
• Duplicated? yes
• Standby Busied? no
• Standby Refreshed? yes
• Standby Shadowing: on
• Duplication Link: up
File synchronization then occurs.