Job Aid Replacing the Avaya S8700 Media Server—Release 2.0 and Later
Replacing the S8700 Media Server
Replacing the Media Server with Release 2.0—S8700 13
December 2003 555-245-767, Issue 1.1
NOTE:
There is no need to remove the hard drive from the bracket.
Figure 2: Hard drive bracket and hard drive
Replacing the cover on the failed S8700 Media
Server
For these steps, see Removing and replacing the cover on the media server on page 12
1 Replace the cover onto the media server. Be sure the inner rail guides of the cover set correctly on
the bottom rails of the media server.
2 Slide the media server cover forward so the covers’ tabs slide into place under the top slots of the
front panel.
3 Screw the two cross-point (Phillips) screws into the back of the media server to hold the cover in
place.
4 Reattach the brackets to the sides of the cover with the hex-head bracket screws.
1 Faceplate Screw
2 1/8 to 1/4 inch gap
3 Hard Drive
4 Bracket Screws
5 Power Cable
6 Ribbon Cable
7 Position of Red Stripe
drdsdrtp LAO041503
S/N 0263J1BR633545 V11P204
W
A
R
R
A
N
T
Y
V
O
I
D
I
F
R
E
M
O
V
E
D
P4
1
2
3
4 4
4 4
1
5
6
7
To Next Page
Loading...
