Job Aid Replacing the Avaya S8700 Media Server—Release 2.0 and Later
Expanded Procedures
20 Replacing the Media Server with Release 2.0—S8700
555-245-767, Issue 1.1 December 2003
5 Select the correct security (security_) file (the most recent one is at the top) and click Restore.
CAUTION:
Do not restore the translation file as the one on the good media server has the most current
translations.
6 Click Status to view the Restore status. When the restoration is complete, the message Restore
is finished
displays.
Verifying media server configuration
1 Under Server Configuration, click Configure Server to start the configure server process to open
the first page of the Configure Server process.
2 Click Continue through the Review Notices to get to the Specify how you want to use this wizard
page.
3 Select "Configure all services using the wizard."
4 Click Continue through all the screens to verify that the configuration is complete and correct. Be
sure to set the server number (1 or 2) under Set Identities.
NOTE:
You may need to reset the port speeds for the Ethernet interfaces.
NOTE:
You do not need to fill in the static routes for Release 2.0 and later.
5 When you complete all the new fields, click Continue on the Update System screen. The Update
System screen displays each configuration task as it completes.
When done, the screen displays
All configuration information was entered.
6 Click Close Window to close the Configure Server wizard.
To Previous Page
Loading...
