© 2016 Avaya Inc. All rights reserved. NDA Confidential; use pursuant to your agreement.
Release Notes for Avaya Scopia® XT Series What’s New | 10
Post-Provisioning an XT Endpoint
If you don't have the code for a specific endpoint, because it has not yet been provisioned in Avaya
Equinox® Management, you can insert the Server Service Code of your Avaya Equinox®
Management, and leave the Endpoint Service Code digits empty or all zeroes (post-provisioning
code). This feature is called Post-Provisioning. In this case the Avaya Equinox® Management
Admin will be notified that an endpoint, not yet provisioned, has been added to the list of the
manageable endpoints and can be configured any time later.
This way, an IT administrator can plug all the XTs in all the company conferencing rooms, just
inserting the same post provisioning code; then set a mnemonic name for the endpoint and
configure it later in Avaya Equinox® Management, where it will be displayed with a red clock icon
near the name.
You can then specify a set of basic/advanced settings for an endpoint, or delete the endpoint if you
don't want to provision it any longer.
Figure 2: Post-provisioned Endpoint Listed
Auto Provisioning FAQ
[Q]What is the default for Auto-provisioning in XT endpoints?
[A]The default depends on the installation of the XT and if it was already managed by an Avaya
Equinox® Management entity. If the XT is a newly installed endpoint or it was not managed, the
default will be “Cloud”; otherwise it will be “Local”. The Local Mode will be automatically changed to
“Cloud” when the Avaya Equinox® Management entity managing the endpoint is updated to this
solution release.
[Q]How to check if my XT is managed through the cloud or not?
[A]Check Configure>Advanced>Utilities>Remote Access>Avaya Equinox® Management
Mode: Cloud (Connection using auto-provisioning)/ Local (Connection to Scopia
Management 8.3 version or earlier)
If the connection Mode is “Cloud”, your XT is connected to Avaya Equinox® Management using a
secure web socket. Status of the connection is visible in XT Web home page or in System Status>
More.
[Q]What happens if I load factory defaults on a provisioned XT?
[A]Your XT will remember the Service Code inserted for Provisioning and will propose it again (only
the first 5 digits are needed). Just press “Next” in the initial wizard to have your XT configured again
with the same Avaya Equinox® Management.
[Q]How can I associate my XT to a different Management Server with auto provisioning?
[A]Ask your administrator to remove your XT from the Management Server and to add it to a new
Management Server. Once you received a new Service Code, load Factory defaults on your XT.
You will be prompted to insert the Service Code for the Management Server. Insert the new one you
received.
[Q]How can I associate my XT to a different Management Server manually?
[A]Ask your administrator to remove your XT from the first Management Server and to add it to a
new Management Server manually. You will be disconnected from the first server and connected
automatically to the second one.
To Next Page
Loading...
