© 2016 Avaya Inc. All rights reserved. NDA Confidential; use pursuant to your agreement.
Release Notes for Avaya Scopia® XT Series Common Remote Control Shortcuts | 86
Simplified Remote Control Shortcuts
Figure 49: Simplified Remote Control
To connect the Simplified Remote Control Unit to a specific XT endpoint (necessary if
there are multiple Codec Units in the same room):
In the web interface, navigate to Basic Settings > General > Remote Control
Code.
Enter two-digit code for the Remote Control Code (from 01 to 96 to control
the Codec Unit). The default code is 01. Press the '*' and '#' keys
simultaneously on the Remote Control Unit until the red led blinks twice. Enter
the two-digit code inserted in the web interface.
The code programmed in the Remote Control Unit must match the setting
configured in the GUI Configure > General > Remote Control Code or in the
Web > Basic Settings > General > Remote Control Code.
Codes 97, 98, 99 are reserved to control an Avaya XT Series XT Deluxe
Camera, and cannot be used to control the Codec Unit.
The 'layouts' key controls the visibility of the secondary video window (PiP/PaP/PoP/Full
screen) and corresponds to the 'pip' key on the Advanced Remote Control (described in
next section).
The hold of the 'layouts' key controls the content of the visible video windows. This can
be used also outside a call.
The 'del' key corresponds to the 'C' key on the Advanced Remote Control (described in
next section).
To erase the input from a field, press and hold the 'del' key.
To quickly move the current camera when you are in the Main menu, press the 'del' or
the 'back/undo' key on the Remote Control. Press 'del' again to access the Main menu.
During a call the title bar and the call page disappear after a few seconds. The header is
automatically reactivated when mute/privacy/DND is activated. You can hide or access
the title bar and call menu by pressing the 'del' key on the Remote Control Unit. From the
Main menu, you can also press the 'back/undo' key on the Remote Control.
You can press the '1/a/A' key to quickly toggle the input editing mode of the Remote
Control between numeric-only/lowercase letters and digits/uppercase letters and digits.
Press and hold the 'mute' key to mimic the function of the 'privacy' key on the Advanced
Remote Control.
[XTE240] In the Layouts page, press the 'near/far' key to switch between your computer
and the remote computer.
When connected to a Solution Meeting, press the 'near/far' and then the 'layouts' key to
cycle among the supported Meeting layouts
Press and hold the 'near/far' key to mimic the function of the 'inputs' key on the Advanced
Remote Control.
Caution
Do not disconnect or power off the system to switch off.
Press and hold the 'on/off' key on the Remote Control to switch off the system.
To Next Page
Loading...
