© 2016 Avaya Inc. All rights reserved. NDA Confidential; use pursuant to your agreement.
Release Notes for Avaya Scopia® XT Series Common Remote Control Shortcuts | 87
Advanced Remote Control Shortcuts
Figure 50: Advanced Remote Control
The 'pip' key on the Advanced Remote Control controls the number and the layout of
visible windows on the screen. For instance you can choose to see the remote video in a
big window and your local video in a smaller window on the upper left corner. This
corresponds to the 'layouts' key on the Simplified Remote Control.
The 'layouts' key on the Remote Control controls the content of the visible windows on
the screen. For instance you can decide to see the remote video or the local video on the
bigger window. This corresponds to holding the 'layouts' key on the Simplified Remote
Control.
The 'C' key corresponds to the 'del' key on the Simplified Remote Control (described in
next section).
Press and hold the 'C' key to completely erase field content in the GUI.
To quickly move the current camera when you are in the Main menu, press the 'C' or
'back' key on the remote control. Press 'C' again to access the Main menu.
During a call the title bar and the call page disappear after a few seconds. The header is
automatically reactivated when mute/privacy/DND is activated. You can hide or access
the title bar and call menu by pressing the 'C' key on the Remote Control Unit. From the
Main menu, you can also press the 'back' key on the Remote Control.
To customize the use of the Advanced Remote Control Unit, press together the 'red' and
'green' keys on the Remote Control Unit, then press the relevant digit keys to type a two
digit code (from 01 to 96 to control the Codec Unit). The default code is 01. The code
programmed in the Remote Control Unit must match the setting configured in the GUI
Configure > General > Remote Control Code or in the Web > Basic Settings > General >
Remote Control Code. Codes 97, 98, 99 are reserved to control an Avaya XT Series
Deluxe Camera, and cannot be used to control the Codec Unit.
To switch between controlling the local and remote camera, press 'far' or 'near'. When
the 'far' icon appears, all input selection, presets, camera movements and zoom actions
are directed to the far camera. In a meeting, the actions are directed to the current far
active speaker.
You can press the 'inputs' key to quickly zap between the available local or far cameras
To check the call status and diagnostics during a call, press the 'help' key on the Remote
Control.
Press and hold the 'privacy' key to toggle Do Not Disturb. Press and hold the 'mute' key
to toggle 'privacy'
When connected to a Solution Meeting, press 'far' and then 'layouts' key to cycle among
the supported Meeting layouts
You can press the 'ok/menu' key to quickly toggle the input editing mode of the Remote
Control between numeric-only/lowercase letters and digits/uppercase letters and digits.
[New] In the Call page, press and hold 'ok/menu' to toggle the input editing mode, and
press 'ok/menu' to place a call.
[New] In XTE240, used as personal or shared endpoint, you can press and hold 'inputs'
to toggle between your pc and the remote content, when receiving a presentation.
To access and save camera positions, press 'presets memo' or 'presets select'.
You can store and recall up to 122 presets. Presets selection is supported as follows:
To Next Page
Loading...
