AVer EVC170 - Aver Evc Wizard Setup; Start; Language

19
AVer EVC Wizard Setup
For the first time using AVer EVC system, the Installation Wizard will guide the user to setup EVC
system step by step. After completing the wizard setup, user may start to use the EVC system.
In Installation Wizard, user can use the following buttons on remote controller to move between the
selections and make/confirm selection.
: To expand the drop-down list, make/confirm the selection.
/ : Move the cursor up or down.
: Move the cursor to right or on
Next
button.
: Move the cursor to left or on
Back
button.
Start
Please follow the below description to complete the wizard setup.
Connect your EVC system well and turn on the
power. After your EVC system starting, user will
see the Installation Wizard screen shown up.
If you want to pass the Wizard setup, press
button move to
Skip
button and press
to go to Home page.
Language
Select the language of the EVC system.
Press to expand the drop-down list. Then,
use or button to move the selection and
press to make the selection. After selecting,
press to move to Next option and press
to go next step.