53
3. Configure the below settings and then click Confirm.
Local Device Name: Enter a name of the camera to be shown within NDI devices. For best
results, name all AVer cameras the same Local Device Name. e.g. PTZ Cameras or Tracking
Cameras.
Device Channel (Camera ID): Enter a channel name for the camera. The channel name is an
identity name for the camera to be displayed within NDI devices. AVer_NDI_Camera is set up
as default. The maximum character is 10. The following characters are supported:
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
! @ % ^ , . / : + ? [ ] { } - _ ~
Receive Group: Enter a name of the receive group. The Receive Group allows you to limit
which users on your LAN can see the NDI source. For best results, the Receive Group should
remain Public. Once the Receive Group is changed, you will need to join the Receive Group
through NDI® Access Manager.
Reliable UDP: Check the box to enable the UDP protocol.
Discovery Server: Check the box to enable Discovery Server. Input the IP address in the
Discovery Server Address column.
Multicast Server: Check the box to enable Multicast Server. Input the related info in the
Multicast Server Mask and Multicast Server Address columns. You can use the Multicast
TTL to adjust the Multicast Time-To-Live interval.
4. The NDI setup is completed. If you want to disable NDI, go to Video & Audio setup page and
select any other video source from the Video Mode list.
To Next Page
Loading...
Need help?
General
