52
NDI
You can activate the NDI function using this page. Camera firmware version v31 and later supports
NDI function.
To set up the NDI function:
1. Get an NDI license key.
This camera is compatible with NDI|HX of NewTek, Inc. To use NDI|HX, you are required to
purchase the license key from the URL of NewTek, Inc.
https://www.newtek.com/ndihx/products/upgrade/
2. Activate the NDI license key.
a. Ensure the camera has been connected to the Internet.
b. Check whether the firmware version of the camera is v31 or later to support the NDI function.
c. On the camera Web page of NDI, click the NDI Activate Function button to enter the license
key and then click the Activate button. A message pops up for camera reboot. Click OK to
reboot the camera.
d. After activating the license key, you should see the NDI option on the Video Mode
drop-down list. Select NDI to enable the NDI function. Please refer to Video Mode in <Video
& Audio>.
[Note] When NDI is enabled, the camera cannot support other video output source.
To Next Page
Loading...
