20
Set Up the Camera
OSD Menu
You can use the supplied Remote Control to operate the OSD Menu. Press the button to call
out the OSD menu and use the
▲
,
▼
,
,
and buttons to operate the OSD menu.
IP Address Setup
Static IP
1. Press the button on the remote control to call out the OSD menu.
2. Go to Network > Static IP.
[Note] Turn the DHCP off before setting up static IP (Network > DHCP > Off).
3. Select the IP Address, Gateway, Netmask and DNS to configure. Press and use
,
and Numeric Pad to enter the data.
To Next Page
Loading...
Need help?
General
