Troubleshooting 386
5 Touch Assign. The selected CTM flashes to indicate it is the module targeted for assignment.
If the wrong module is flashing, touch Cancel, touch the correct module so it is bordered in orange, and then touch Assign.
6 Touch the real CTM, which displays the message “Touch to Configure.”
When the CTM has been reconnected, the Meters view appears on-screen.
Offline or Unavailable Devices
The S6L system remembers the last hardware configuration used. If it doesn't find all units at the next startup, it displays those de-
vices as grayed out in the Options > Devices page. Devices remain offline (and the system displays error messages alerting you to
their absence) until either the devices are powered up and come online, or you tell the system to “forget” the offline devices.
Forget an offline device if that device is not currently a part of your configuration. If your device has failed or lost its connection,
check audio network connections or power-cycle the device.
To forget offline devices:
1 On the external screen, go to the Options > Devices page.
2 Touch-and-hold (right-click) the missing device and choose Forget.
Control Surface Configuration window showing a CTM ready to be assigned
CTM showing Touch to Configure
To Next Page
Loading...
Need help?
General
