Avision FF-2009B - Page 143

User’s Manual
7-8
3. On the scanner, select [WPS] and press (OK) to enter
WPS mode.
If Wi-Fi appears in the WPS option, this indicates the
WPS mode of the scanner is ready. Please connect to your
specified access point or router within 2 minutes.
4. To verify if the WPS connection is successful, you may
check the connected AP by selecting [Info]>[Wi-Fi]. The
connected SSID (network name) and its Mac address will
be displayed.
Wi-Fi On
Wi-Fi Direct Link Off
WPS
Sleep Mode Off
Information
Clean Mode
Wi-Fi On
Wi-Fi Direct Link Off
WPS
Sleep Mode Off
Information
Clean Mode
Wi-Fi On
Wi-Fi Direct Link Off
WPS
Sleep Mode Off
Information
Clean Mode
Scanner
Wi-Fi
Ethernet
Counters
Station IP
125.3.2.5
SSID:
XXXXXX
MAC Address:
200abc-xxxxxx