Figure 46: WebGUI > SYSTEM > Reboot
Click on the button Reboot to reboot the camera. It will be ready for use again after the boot cycle.
Follow instructions below if you want to create a new reboot schedule.
1. Enable "create new reboot: status".
2. Select at "occurrence" the month and day and select the time you want to reboot the camera. Take
note that Amsterdam/ European timezone is used.
Serial Settings
Figure 47: WebGUI > SYSTEM > Serial Settings
You can choose the preferred protocol to use and the accompanying address to go with it. Or you can select the
default protocol type 'Auto' to let the camera detect which protocol is being used. Addressing is still needed, even
with the automatic setting.
Click SAVE to apply your settings. A small confirmation dialogue appears in the bottom right corner.
Import/Export Parameters
Figure 48: WebGUI > SYSTEM > Import/Export
The cameras have the ability to import or export a configuration.
Select the appropriate button to import or export your configuration parameters and follow the steps.
The exported settings do NOT include any presets that are stored in the camera!
47
To Next Page
Loading...
