P/T/Z
Figure 49: WebGUI > SYSTEM > P/T/Z
In this window, you can define various P/T/Z settings for your camera. These are:
PTZ Speed Increases the maximum pan and tilt speed. This can be useful in a conference system where quick action
is necessary. The camera will produce slightly more noise when this option is set to ‘high’.
Speed by zoom Affects the PTZ speed when the camera is zoomed in to its max. If you move the stick of your controller
when this mode is disabled, the camera will move too fast to control it. Enabling reduces this speed in
relation to the current zoom factor.
Image Freezing * Freeze the image when the camera moves from one preset to another when the (remote) controller is
used.
Low Power Mode: The camera will enter stand by mode to reduce its power when this mode is enabled. In order to reduce
the power the camera uses, the camera will shut down the IP Port. To activate the camera again, use a
serial connection or the IR Remote to turn off the Low Power Mode.
Enable/ Disable Infrared
Receiver:
Enable/disable the Infrared Receiver. When you disable the Infrared Receiver and the Low Power Mode is
enabled, it will NOT be possible to activate the camera again using the IR Remote Control.
Zoom Speed Set the speed to which the camera will zoom in to the image. The higher the number, the faster the
camera will zoom in. This works only when the remote controller is used to control the camera.
Preset Pan, Tilt and Zoom Speed This mode affects the speed to which the camera is switching from one preset to another when you use
your (remote) controller. The higher the number, the faster it will switch.
* Before freezing the image, ensure that the audio is turned off if you are using it during streaming. Freezing the image could produce
a paused audio output on the IP Stream. This leads to (audio) stuttering. The video stutters when it is re-engaged, but this is rather easily
solvable by putting the iFrame value at 4 or 5 times per second. That is quick enough to counteract the video stutter.
MJPEG Snapshot
The Avonic CM93 camera is equipped with a MJPEG snapshot feature for implementation into third party software
for example. Every time the page is refreshed, the picture will be updated.
To access the MJPEG snapshot feature, use the following format: http://IP/img/capjpg/snapshot.jpg.
See also MJPEG Snapshot on the website.
48
To Next Page
Loading...
